News

There Are Two Possible Sparks When Converting Motors?

Mar 11, 2024 Leave a message

(1) Electromagnetic reasons: During the conversion of the motor, the converted components will generate conversion potentials, and when the sum of these potentials is generally greater than zero, it will prolong the conversion time. After the conversion, if the back direction of the DC motor leaves one of the adjacent sides of the conversion, and the converted current is not zero, the electromagnetic energy will generally be stored in the converted components. If it leaves the electric brush again on the previous conversion surface, the conversion path will suddenly stop, and the electromagnetic energy in the converted components can only be directly released from the air. When all of these situations occur simultaneously, sparks will definitely appear.
(2) Mechanical reasons: In the manufacturer's motor production process, motor defects caused by mechanical conversion are a significant part of the reasons. There are many reasons for mechanical defects, such as:
1. The parallel surface of the machine is not clean during conversion;
2. The pressure spring model on the surface of the electric brush is incorrect;
3. The conversion chip is not up to standard, resulting in the insulation device being elevated;
4. The surface of the electric brush is not smooth enough, causing the transition surface of the electric brush to not fully adhere;
5. The parallel surface of the converter itself is not smooth enough. During installation, the converter cannot achieve parallelism with the electric shaft of the DC motor;
6. When the distance between each electric brush rod cannot be the same, the converter component of the electric brush short circuit cannot be at the center point of the large device;
7. The improper size of the outer box of the electric brush is the main culprit causing sparks to be generated by the motor.

 

Send Inquiry