Knowledge

What is the maintenance cycle of MILL AC Motor?

May 09, 2025 Leave a message

Daily maintenance
1. Daily inspection: Keep the external environment of the motor clean and tidy, regularly remove dust and oil stains on the outside of the base, and ensure that the air inlet is unobstructed. Check whether the motor terminals are in tight contact and not loose, and check all fixing screws, including anchor screws, end cover screws and bearing cover screws.
2. Weekly inspection: Carry out necessary spot checks on key process equipment and key equipment, and arrange for timely treatment if problems are found.
Regular maintenance
1. Monthly inspection: Check the insulation resistance of the motor to ensure that it is in good condition and effectively prevent safety hazards such as leakage. At the same time, the grounding of the motor housing should be checked to ensure that the grounding is firm and the housing is not damaged.
2. Quarterly inspection: For possible faults, such as abnormal heating, excessive no-load current, etc., the cause should be quickly identified and repaired.
Overhaul cycle
1. Annual inspection: Replace severely worn brushes, thoroughly remove dust from the motor cooling fan, and check the fan condition.
2. Inspection every two years: clean the dust from the rectifier device, thoroughly clean the dust from the rectifier cabinet fan and air duct, and check the fan condition.
3. Inspection every five years: for large DC motors, plate roller motors and auxiliary equipment (fans, lubrication, etc.), replace most of the brushes in poor condition, polish and sand the commutator surface, and conduct motor characteristic tests.

MILL AC Motor

Send Inquiry